Maxtrax Roof Rail Mounting Kit 1

Mounting kits to fit your Maxtrax 2 Recovery boards (No affiliation), directly to the original roof rails on Land Rover Discovery 3 & 4

Recovery boards are removed from the rear (not top) and takes approx. 1-2min

Rear holders released either by toolless screw levers or fixed Alun bolts

 

2 946 Kč 2 434,71 Kč excl. VAT
In Stock In Stock Choose variant

These mounting kits are specifically designed to fit your MXT-2 recovery boards directly to the standard roof rails on a Land Rover Discovery 3 & 4

No need to buy a full roof rack, or swing out carrier just to mount your recovery boards, they can simply mount directly to your existing roof rails

The boards are installed & removed from the rear of the vehicle and are mounted directly to pads on the roof rails, so they add very little height to your vehicle, the final height of the boards above the rail is approx. 95mm (85mm for 2 stacked boards, plus approx. 10mm of mounting bracket pad on the rail)

Low height means you are more likely to fit your vehicle into a domestic sized garage and the top of the recovery boards are lower than most roof bars, so do not obstruct the items you normally fit on top of the bars e.g. roof tents, boxes etc

Easy kit fitting with only basic tools, these parts just slide into the end of the roof rails via the end caps (Note - you may need to slightly modify some existing rail holes, for centring the new locking parts, please see the downloadable fitting instructions for more details, in the ‘Related Files’ icon, next to this text block

Basic process for fitting and removal of the boards from the mounting kit:

  • Put the lower tailgate in the open position, with the upper half closed
  • Stand on the lower tailgate, this puts the boards at approximately lower chest height, so it is easy to remove them from the roof as your shoulders are above the boards
  • Unscrew two Alun bolts (one on each rail end), slide out the rear mount caps approx. 10-15mm & turn them 90deg outwards
  • The boards can now be easily lifted into or out of the rails and passed too and from the ground
  • For mounting system closure when no boards are fitted, simply re-turn the end mounts 90deg back to the rails, slide them into the rails for lock/location, push the end caps into the rails and gently tighten the Alun bolts
  • Closure when boards are fitted, is the same, except there is a simple centring procedure needed to stop recovery board rattling that is described in more detail in the downloadable instructions

All plastic parts made with UV resistant material for outdoor use, combined with A2 grade stainless steel hardware, these parts will not rust/discolour your rail (a picture of all supplied parts is included in the pictures section)

The printed parts have visible 3D printed layers and post processing by hand related marks, hence the parts do not have a smoothed/polished appearance and no two parts are completely identical

It is possible to smooth the surface of the brackets as to modify to your own needs, but explanation how is not within the scope of this sale

We recommended using thread lock on the fasteners, to help stop parts coming loose under vibration through hard body movements

Parts are manufactured and stored in the Czech Republic by 3DP Designs.

Code Code: 58/BLA2 58/BLA3 Choose variant
Brand name: 3DP Designs
Category: Recovery Board Rail Mounting Kit
Back shopping